Transformer pads (precast or poured in place)

Generator pads

Light pole bases (parking lot or site lighting)

Trench infill after underground conduit runs

Electrical room slabs (if separate from the main building or at grade)

Conduit block-outs in slabs or walls

Slab trenching/cutting to access or install new lines (demo + pour-back)

Sleeves/blockouts for pipe runs through slabs or grade beams

Pad installs for water heaters, booster pumps, and backflow cages

Pour-back after rough-in or repair work in existing buildings

Grease trap slab installs (commercial kitchens)

Equipment pads for AC units, condensers, chillers, or rooftop units (on grade or rooftop castings)

Slab blockouts for duct or refrigerant lines

Pour-back or infill around floor penetrations

Curbs or housekeeping pads for interior mechanical equipment

Pad installs for fire pumps or riser assemblies

Wall/floor sleeves for riser and branch lines through slabs

Pour-back work around slab or beam penetrations

Trench fill-ins (if the underground fire main is routed under concrete areas)

CMU stem wall footings

Grout beds or leveling pads

Slab edge prep for brick ledge or façade anchoring

Concrete embeds or anchor points for steel columns

Hardscape installation 

Retaining mow strips 

Decorative concrete

Slabs and footers for outdoor structures